|
Static and Dust Fundamentals - 42 (Table of contents) |
Until the last number, we had covered 2 Problems caused by the static, 3 Fundamentals of the static, 4 Fundamentals of dust, 5 Fundamentals of antistatic and anti-dust measures, and 6 Antistatic and anti-dust measures of new age. In this number we discuss a sequel to 7 Anti-static/dust measures with full of errors.
7.Antistatic and anti-dust measures with full of errors
7-15. Anti-static/dust measures at plastic factories
7-15-1. It’s too hard to house a whole resin mold factory in a clean room.
7-15-2. Static-elimination (ionization) on dies
7-15-3. Static elimination (neutralization) of the object after injection
7-15-4. Static elimination (neutralization) on the object retrieving system
7-15-5. Static-elimination (ionizing) on the work moving on the conveyor
7-15-6. Static-elimination (ionizing) on the products impossible to pile up
7-15-7. Static elimination (ionizing) at the inspection process
7-15-8. Dust elimination (remove)
7-15-9. Pellet static-elimination (ionizing)
7-15-8. Unsolved problem
At the end of the issue
|